After-Storm Chimney Checklist — Annapolis & Anne Arundel County
Chesapeake Bay storms — particularly nor’easters and summer thunderstorms — are among the most common causes of acute chimney damage in the Annapolis area. This checklist covers the post-storm assessment steps homeowners can perform from the ground, plus the indicators that require a professional inspection before the fireplace is used again.
Immediate Post-Storm Steps (Ground Level)
- Do not use the fireplace until an inspection is complete — storm damage to the chimney stack, cap, or liner may not produce visible interior signs but can create CO or fire risk on the first use.
- Look at the chimney top from the yard — verify the cap is still present and seated. A displaced or missing cap after a wind event means the flue is now open to the elements and may have received rain or debris during the storm.
- Check for displaced brick or masonry debris — brick, mortar chunks, or chimney cap fragments on the roof or yard are evidence of physical impact or wind damage to the chimney stack. Document with photos.
- Inspect the roofline around the chimney — look for displaced shingles, lifted flashing, or visible gaps at the chimney-roof joint. Flashing lift after a storm is common at Annapolis waterfront addresses exposed to southwest or northeast wind.
- Check interior ceiling near the chimney — new water staining on ceilings adjacent to the chimney is evidence of active moisture intrusion through compromised flashing or masonry.
When to Schedule a Professional Post-Storm Inspection
- Cap is displaced, missing, or damaged
- Any brick, mortar, or chimney cap fragments found on roof or ground
- Visible lifted or separated counter-flashing
- New ceiling staining near the chimney
- Lightning strike on or near the chimney (requires Level II inspection even if no visible damage is present)
- Tree limb impact on the chimney (requires structural assessment)
- Major storm at a waterfront Annapolis address (Bay Ridge, Annapolis Neck, Eastport, Riva) even without visible damage
Lightning Strike — Level II Required
Lightning strikes are a special case. NFPA 211 requires a Level II camera inspection after any lightning strike on or adjacent to a chimney — because the thermal shock from a strike can crack clay tile liner sections or damage masonry joints in ways that are not externally visible. Do not use the fireplace after a lightning strike until a Level II inspection confirms liner integrity.
Documenting Storm Damage for Insurance
If storm damage to the chimney will result in an insurance claim:
- Photograph all visible damage from multiple angles before any cleanup or repairs
- Photograph the damaged roofline and flashing from the roof level if safe to access
- Request a written inspection report from your chimney service provider that documents: storm event date, damage found, probable cause, and itemized repair recommendations with pricing
- Contact your insurance company before authorizing non-emergency repairs — most policies require pre-authorization for covered repairs above a minimum threshold
Frequently Asked Questions
My chimney looks fine after the storm. Do I still need an inspection?
For waterfront Anne Arundel County addresses after a major nor’easter or severe thunderstorm — yes. Flashing lift and liner stress from wind-driven rain are not reliably visible from the ground. A brief post-storm inspection (typically less expensive than a full annual service) is worth the cost to rule out hidden damage before the fireplace is used.
How quickly should I schedule a post-storm inspection?
Within two weeks of the storm event. Most post-storm damage that is not visible from the ground becomes apparent to inspection within that window; waiting longer risks additional water infiltration through any compromised joints.
Post-storm chimney inspection — Annapolis & Anne Arundel County
(667) 493-2060 — Schedule Inspection